The kitchen sink sprayer, also known as a spray plant, located on the upper side of the sink faucet. If not used or broken, you can remove and use the hole by installing a kitchen sink soap dispenser. This eliminates the clutter of having soap dispensers at its counter. The process involves simply disconnect the sink spray faucet and screw the soap dispenser in place.
Open the hot and cold water under the kitchen sink soap dispenser turning the buttons to the right until the end. Open the faucet to let the water remaining in the lines. Unscrew the hose from the valve under the sink using adjustable pliers. Remove the sink sprayer up and away from the sink, pulling the loose hose out through the same hole. Wipe the edges of the hole with a damp cloth.
Push the threaded end of the reservoir to the kitchen sink soap dispenser hole. Screw the ring dispenser on the threaded end of the container to hold it in place. Pour your choice of soap in the tank until it is full. Lower the pump into the tank and screw in place until firm.
How to Install Kitchen Sink Soap Dispenser
Most families keep a pump dispenser of hand soap near the kitchen sink, but often fall off the counter and ends in the dishwater. To avoid this problem, why not install a kitchen sink soap dispenser? It is not difficult and constantly eliminates fumbling a plastic container pump ends in the sink or dishwasher.
Instructions to install kitchen sink soap dispenser: see if you have a spray attachment next to your tap. If not, then you probably will see a pop-out cover round, usually to the right of the key. Put a knife blade under the disk and must leave. Remove the dispenser pump soap package.
Get under the sink and screw the plastic bottle into the hole and into the threaded inside the ring. Use a small funnel placed on top of the ring to fill the plastic bottle three-quarters full with liquid hand soap.
Finally, to install kitchen sink soap dispenser, place the long tube attached to the bottom of the pump in the center of the ring and allow the pump to rest on top of the ring. Press down repeatedly on the pump to start the flow of soap through the pump.