Hardware kitchen cabinet not only adds functionality to your cabinets, but can leave a beautiful design that gives elegance to your kitchen. The knobs, pulls and handles can match your other metals in your kitchen, like your faucet, or you can mix and match for a unique look. With a few simple steps, you can install new hardware cabinet and put the finishing touches to your –Kitchen Cabinet Hardware Pulls
Before you begin, make sure that you are working on the right side of the closet door that opens. It is very easy to get confused when there are no existing controls. By placing the tape, center it on the door track, which is the vertical edge of the closet door. (The style is the horizontal edge of the door in the terminology of the kitchen cabinet hardware pulls.)
The easiest way to attach the kitchen cabinet hardware pulls is to first place a block of wood behind the area to be drilled to prevent a blow out of the hole. Using a brad point drill or a drill bit that is the size of the diameter of the screws, with your drill on the slowest setting, makes a small hole.
How to Install Kitchen Cabinet Hardware Pulls
Installing kitchen cabinet hardware pulls increase the functionality of your cabinets. Cabinet pulls make opening the door and drawer easier and add a custom look. Different types of hitches are available depending on your style. These hitches can be purchased at any store home improvement. Do not hire a company to install his cabinet strip; Do it yourself and save money.
To install kitchen cabinet hardware pulls are Place a small amount of tape on the front of the door, where you will be drilling. Measure pulls to determine the space between the holes, using a tape measure. Mark a line where the holes are drilled, using a tape measure and a pencil. Always check your measurement before drilling holes.
Drill holes in the cabinet door using an electric drill and a drill. You will need a bit of 3/16. Some kitchen cabinet hardware pulls may require a bit of a different size. Drilling through wood slowly to maintain the wood chipping. Remove the tape from the closet door. Replace the screws that come with the Yanks in the ore-drilled in the back of the closet door holes. Place the cabinet to pull the screws in place and tighten, using an electric drill.